Hunter Fan Type - Manual (Page 15)

15
45075-01 • 03/29/11 • Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Lower Switch
Housing
Step 7-11
Step 7-14
Step 7-15
Switch Housing
Cap
Plug
Button
Uninstalling the Light Fixture
7-8. Remove the housing assembly screws, then remove the lower
switch housing.
7-9. To uninstall the light fixture, disconnect the plug connectors
between the black wire and the black wire with a white stripe.
Disconnect the plug connectors between the two white wires.
7-10. Remove the nut and washer from inside the center of the lower
switch housing.
7-11. Unscrew the light bulb socket. Pull the small (male) plug
connector through the hole in the center of the lower switch
housing. Then, pull out the large (female) connector.
7-12. Install the dummy terminals (included in the sack parts) on the
two disconnected wires in the lower switch housing.
7-13. Remove the light fixture bracket by removing the 2 screws
attaching the bracket to the lower switch housing.
7-14. Install the switch housing cap and plug button to the lower switch
housing.
7-15. Connect the upper plug connector from the motor to the lower
plug connector in the lower switch housing. Attach the lower
switch housing to the upper switch housing with three housing
assembly screws.
Housing
Assembly
Screw
Light Bulb
Socket
Step 7-10
Plug
Connector
Nut
Washer
Step 7-13
Male Dummy
Terminal
Female Dummy
Terminal