Hunter Fan 30023 - Manual (Page 4)

41783-01 06/10/2005 4 © 2005 Hunter Fan Company
Using Your Air Purifier
1. Place your PermaLife ™ Air Purification System on a hard, flat surface. We recommend
placing it on a table top in order to achieve the best air circulation for the room.
2. Plug the unit into a 120V electrical outlet.
3. Select a speed by sliding the speed selector to the appropriate location. The red power
light will be illuminated when you have selected a speed.
4. Turn the ionizer ‘on’, by sliding the ionizer switch to the ‘on’ position. The green light
will be illuminated when the ionizer is ‘on’.
NOTE: The ionizer can release negative ions when the fan is not blowing. If it is used
consistently without the fan, the dust particles that are attracted to the negative ions
may deposit on your walls and floors. To minimize these deposits, we recommend that you
use the ionizer only when the fan is blowing (when the unit is on LO, MED, or HI speed).
Cleaning Your Air Purifier
Proper maintenance of your Hunter Air Purifier will help ensure years of trouble free
service.
Follow these steps to properly maintain your air purifier:
1. Approximately every 90 days, the outside of the unit should be cleaned with a soft,
damp cloth.
2. If needed, the front grill can be removed from the unit and cleaned with soapy water.
Simply remove the pre-filter before exposing the grill to water.
3. Follow the instructions in the Cleaning the Filter and Pre-Filter section to determine
when to clean the filters.
NOTES:
• The air purifier must be unplugged during the cleaning process.
• Be sure the unit is completely dry before plugging in and using.
• Never immerse unit in water.
Cleaning the Filter and Pre-Filter
The PermaLife ™ Filtration System uses a cleanable filter that never has to be changed, only
cleaned. The proper time to clean the filter depends on usage and the environment. Use the
following list to help determine if the filter should be cleaned:
• Compare the color of the filter to the color coded chart on the inside of the housing. If the
filter color matches the darkest color on the chart, you should clean the filter.
• If you notice a decrease in air output or an increase in noise at any time during normal
operation, the filter may be clogged. Clean the filter to return to normal operation.
41783-01_rev 06.10.05.pmd 6/10/05, 8:23 PM 4