haier TFT L32C1120 - Manual (Page 26)

24
5. Auto Adjust: Adjust the settings
automatically.
6. Preset: Restore the default VGA
setting values.
TIPS
Care of the screen
Do not rub or strike the screen with
anything hard as this may scratch, mar, or
damage the screen permanently.
Unplug the power cord before cleaning
the screen. Dust the TV by wiping the
screen and the cabinet with a soft, clean
cloth. If the screen requires additional
cleaning, use a clean, damp cloth. Do
not use liquid cleaners or aerosol
cleaners.
Mobile telephone warning
To avoid disturbances in picture and
sound, malfunctioning of your TV or even
damage to the TV, keep away your mobile
telephone from the TV.
End of life directives
We are paying a lot of attention to
produce environmental friendly in green
focal areas. Your new receiver contains
materials, which can be recycled and
reused.
At the end of its life, specialized companies
can dismantle the discarded receiver to
concentrate the reusable materials and to
minimize the amount of materials to be
disposed of.
Please ensure you dispose of your old
receiver according to local regulations.
Haier is committed to safely recycling
electronic products and product materials.
Please check for a local recycling location
in the United States at: 1800RECYCLING.
COM or call 1.800.RECYCLING.
Dolby License Notice and
Trademark Acknowledgement
Manufactured under license from Dolby
Laboratories.
Dolby and the double-D symbol are
trademarks of Dolby Laboratories.
Regulatory Notices – Federal
Communications Commission
Notice
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and the TV.
• Connect the equipment into wall
power outlet on a circuit different from
that to which the receiver is connected.