Healthrider H110i HRTL34306.0 User Manual

Page 9

8. See drawing 8a. Press the indicated tab and re-

move the guard from the console wire with
needlenose pliers. Discard the guard.

With the help of a second person, hold the Console
Assembly (91) near the Right Upright (54).

Remove the ties from the Wire Harness (39) and
console wire. Connect the Wire Harness to the
console wire.

Make sure to connect the con-

nectors properly (see drawing 8b). The con-
nectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again.

IF THE CONNECTORS ARE

NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors
and excess wire into the Right Upright (54).

Console Wire

9. Attach the Console Assembly (91) to the Right

Upright (54) and the Left Upright (53) with four
four Handrail Bolts (8) and four Handrail Star
Washers (5).

Make sure that no wires are

pinched. Start all four Handrail Bolts before
tightening them.

With the help of a second person, carefully lower
the Uprights (53, 54) to the floor.

7. Set the Console Assembly (91) face-down on a

soft surface to avoid scratching the Console
Assembly. Hold the Right Handrail (33), which
has a large hole in the location shown, near the
Console.

Next, insert the console wire and tie into the hole
in the side of the Right Handrail (33). Using
needlenose pliers, pull the console wire out of
the hole near the bracket on the Right Handrail.

Then, set the Right Handrail (33) on the Console
Assembly (91).

Make sure that no wires are

pinched. Start a Crossbar Screw (85) with a
Crossbar Star Washer (7) into the Right
Handrail, and then start two Console Screws
(10) into the Right Handrail.

Tighten the

Crossbar Screw and then the two Console
Screws; do not overtighten the Screws.

Attach the Left Handrail (not shown) to the
Console Assembly (91) in the same way. Note:
There are no wires on the left side.

Console

Wire

Large

Hole

Bracket

Tie

Guard

Tab

Console

Wire