Hotpoint RVM1435 - Manual (Page 32)

1 To replace the bulb, first
disconnect the power at
the main fuse or circuit
breaker panel or pull
the plug.
2 Remove the screw from
light cover and lower
the cover.
3 Be sure the bulb is cool
before removing. After
breaking the adhesive
seal, remove the bulb by
gently turning.
4 Replace the bulb. Close
the light cover and
secure the cover with the
screw. Connect electrical
power to the oven.
Replace the burned-out
bulb with a 120 volt,
40-watt incandescent
bulb (WB36X10003),
available from your
GE supplier.
Cooktop Light
1 To replace the oven light,
first disconnect the power
at the main fuse or circuit
breaker panel or pull
the plug.
2 Remove the front grille by
backing out the 3 screws
along the top. Slide the
grille to the left, then pull
straight out.
3 Remove the charcoal
filter, if present. Reach
into the opening, just
right of center. The light
bulb is located beneath
a light compartment
cover. Press and hold
the center snap while
lifting the tab on the
left corner. Remove the
cover. Remove the bulb
by turning gently.
4 Install the replacement
bulb. Reinstall the
compartment cover and
charcoal filter, if present,
Reinstall the front grille
panel with the 3 original
screws.
5 Connect electrical power
to the oven.
Replace the burned-out
bulb with a 120 volt,
40-watt incandescent
bulb (WB36X10003),
available from your
GE supplier.
Oven Light
32
Remove Screw
Interior Light
Housing
Helpful Information
Light Bulb Replacement