HydroSurge 400A-60 - Manual (Page 7)

Copyright 2007 - Morse Mfg. Co., Inc. Form PL400-60 (0604-____) (Updated 10/2007) Page 7
Maintenance
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and efficient operation.
Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten, adjust, or
replace parts as necessary to prevent failure and maintain proper function.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the hydraulic
fluid. Replace any parts that show signs of wear.
Grease wheel bearings periodically. Oil or grease all moving parts including: the three clevis pins and the surfaces of the boom
which contact the inside of the mast cap, the hinge pin, the gears and sprockets in the tilt drive, and the ratchet and pawl.
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
Operator’s Manual for Morse Hydra-Lift Drum Karrier Model 400A-60
Serial Number 0604 to ____ (MMYY)
The Specialist In Drum Handling Equipment
MODEL 400A-60
Hydra-Lift, 60”, Manual Lift, Manual Tilt