haier HL26ATB - Manual (Page 16)

This TV set has two methods to set channels, which are respectively Scan Channel, Add Channel.
In this section, how to use the remote control to set channel is explained. You can also use buttons on the TV
set to set channel.
Scan Channel
Note : the Channel menu will be only operated in normal TV mode.
Channel menu
- Automatically finds all channels available through antenna or cable inputs, and
stores them in memory on the All Channel List.
When Antenna is selected, the TV will detect antenna signals and will
search for antenna TV (NTSC and ATSC) channels available in
your local area.
When Cable is selected, the TV will detect cable company supplied
signals and will search for cable TV (NTSC, ATSC, QAM modulated)
channels available in your area.
1 Press the MENU button and then use / button to select the
Channels menu.
2 Press the button and then use / button to select Scan Channel.
3 Press the button and then use / button to Select Cable or
Antenna mode.
4 Press the OK button to start searching channel.
While it is scanning for channels, at any point, you can interrupt the scanning
process by pressing the Stop Scan button. Those channels have been scanned
would be stored in the available channel table.
5 After you finish scanning for available channels, you may select DONE to
return the display window . .
Operation
Add Channel
If excessive channel signals of unwanted programs are received in local area,
manual search function is recommended.
1 Press the MENU button and then use / button to select the Channels menu.
2 Press the button and then use / button to select Add Channel.
3 Press the button and then use digital buttons to input channel number
you want to add channel.
4 Press the OK button to confirm.
5 When you are satisfied with your choice, press MENU button to return
to the previous menu.
6 Press EXIT button to return to TV viewing or press button to
return to the previous menu.
/ MENU
16 TFT-LCD TV
Note
Make sure you are in an open environment where there is a good signal while scanning so that it is
able to find all channels more easily.
Note
Make sure your TV is placed in an open environment where is a good signal while
scanning so that it is able to find all channels more easily.
If user does not proceed scan channel in advance, it will take Antenna as the
default source.