haier HWM70-0528T - Manual (Page 6)

Please install and adjust the machine according to the requirement of the mannual.
It is very important to your security and correct operating the machine.
Installation and adjustment
3 Push the " WATER LEVEL "button,select suitable water level
After switching on the power, the washing machine will execute fuzzy program automatically to detect the cloth.
After defection, it can set the water level automatically. To select other water level, first push the "start/pause"
button, then push the "water level" button to set the water level.
4 Push the "PROGRAM/RESERVE" button to select suitable reserve
wash program
After switching on the power, the reserve program is not set to off mode automatically. If you need to
set the washing procedure to be finished at reserved time, please push the "PROGRAM/RESERVE"
button to set the reserve wash program two seconds. Refer to "PROGRAM/RESERVE"
button in Page 11 for selection.
5 Push the "Start/Pause" button
6 Finish washing
After finishing wash it will switch off power automatically
After you open the package, please lean the
washing machine gently down on soft items ( like
the towel cloth, blanket, etc. ). Install the bottom
plate to the bottom of the machine with the eight
screws by across screwdriver, then lift the machine up
gently.See to the figure:
Back
Front
Soft items Screw Bottom plate
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in
unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Fasten Loosen
High Low
the adjustable nut
the adjustable leg
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Install the bottom plate
Adjust the Installation position