HONDA 2010 Insight - Manual (Page 395)

CONTINUED
Remove the wheel nuts, then
remove the flat tire. Handle the
wheel nuts carefully; they may be
hot from driving. Place the flat tire
on the ground with the outside
surface facing up.
Use the extension and the wheel
nut wrench as shown to raise the
vehicle until the flat tire is off the
ground. Place the jack under the jacking
point nearest the tire you need to
change. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
resting in the jack notch.
Remove the wheel cover by
carefully prying under its edge
with the flat tip of the extension.
11. 13.
14.
12.
On LX models
Changing a Flat Tire
T
a
k
ing
Ca
re
of
th
e
U
ne
x
p
e
c
te
d
389
WHEEL NUT WRENCH EXTENSION
JACKING POINTS EXTENSION WHEEL NUT
WHEEL COVER