Hunter Fan 30115 - Manual (Page 3)

FORM 41477-01 Rev 1-29-2001 3 © 2001 HUNTER FAN CO.
Setting Up Your Air Purifier
1. Remove your air purifier from the box and take it out of the clear plastic protective bag.
2. Place your QuietFlo™ Air Purifier on a firm, flat surface.
3. Before turning the Air Purifier ‘on’, you need to open the front grille. To release the front
grille, press the tabs until the front grill slides easily over the tabs. Refer to Figure 1.
4. The HEPA filter is already installed in the correct position, but you need to confirm that
it is fully inserted. To remove, grasp the edge of the filter frame and pull it forward.
Notice the orientation of the flaps and seal, which should be pressed firmly into the filter
opening.
5. The carbon pre-filter is mounted inside the front grille with "hook" tape. Confirm that it
covers the grille vents. Refer to Figure 2.
6. Place the filter installation reminder sticker on the inside edge of the front grille. Circle
the month and write the year of installation for the pre-filter and HEPA filter.
7. Replace the filter and front grille. Be sure that the bottom grille tabs are in position first,
and then push the top of the grille forward until it is closed. The unit is now ready for
normal operation. NOTE: This unit will not operate unless the door is placed in the cor-
rect position.
8. Plug the unit into a 120V electrical outlet.
AIR PURIFIER PARTS
QuietFlo™ 115
FIGURE 1
QuietFlo™ 115
FIGURE 2
GRILL
VENTS
HOOK
TAPE
HOOK
TAPE
TABS
FRONT
GRILL
PRE-
FILTER
HEPA
FILTER
PRESS TO
PULL OPEN
FRONT
GRILL
QuietFlo
0
1
2
3