Hitachi VM-E310A - Manual (Page 55)

Specifications
55
PLAYBACK OF PRE-RECORDED CASSETTE
Symptom
Check Point & Correction
“PLAY” button cannot be engaged. Set the power switch to “VIDEO”
position.
No picture appears on television
screen when “PLAY” button is pressed. Set the television to the
camera/recorder channel (3 or 4)
depending upon the selected channel
in the RF channel select switch of RF
output adapter. (TV is connect to the
camera/recorder by using RF output
adapter.)
Interference on playback picture. When you see the playback picture on
yourTV, adjust fine tuning knob on
television set to obtain best picture.
Picture bends at the top of the TV
screen. TV receiver is older type. It needs to
be modified to work properly with
camera/recorder.
Tape is damaged, try another cassette.
Color of your TV screen is too bright,
too faint or change. TV set has VIR circuit. Turn off during
playback.
Specifications
General Specifications
Power requirements
6V DC
Power consumption VM-E110A: 4.7W (when recording)
VM-E310A: 5.3W (when recording)
Dimensions 3-11/16" W x 4-12/16" H x 8-5/16" D (94mm x 120mm x
211mm)
Weight
VM-E110A: 1.90 lbs (860g) without battery pack, lens
hood, lens cap or cassette
VM-E310A: 1.87 lbs (849g) without battery pack, lens
hood, lens cap or cassette
Operating temperature 32°F ~ 104°F (0°C ~ 40°C)
Storage temperature -4°F ~ 140°F (-20°C ~ 60°C)
Video Recorder Specifications
Format
8mm
Record/playback Two video record/playback heads
Video signal EIA standard NTSC color
Tape speed 14.3mm/sec
Video input 1.0Vp-p, 75 ohm
Video output 1.0Vp-p, 75 ohm
Audio input -7.8dBs (316mVrms)