Harbor Freight Tools 47761 - Manual (Page 17)

SKU 47761 PAGE 17
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure that 1) the Trigger is locked in its off position, 2) the
Power Switch of the Pressure Washer is in its “OFF” position, 3) the plug is unplugged
from its electrical outlet, 4) that the water supply is shut off, and 5) all residual water
pressure is safely expelled before performing any inspection, maintenance, or
cleaning procedures. Point the Gun Assembly (E) in a safe direction and discharge
all remaining pressure. Then, disconnect the Heavy Duty hose from the unit.
2. Before each use, inspect the general condition of the Pressure Washer. Check for
loose screws, misalignment or binding of moving parts, damaged electrical wiring,
damaged High Pressure Hose, damaged accessories, and any other condition that
may affect its safe operation. If abnormal noise or vibration occurs, have the problem
corrected before further use.
Do not use damaged equipment.
3. To clean, remove excess water from the Pump by tipping the unit on both sides to
drain any remaining water from the inlet and outlet fittings. Drain the Detergent
Dispenser and flush with running water. Use only a clean cloth and mild detergent
to clean the body of the Pressure Washer. Do not use solvents. Remove the Inlet
Filter and run water through it backwards to remove any debris.
Do not immerse any part of the tool in liquid. Dry off any remaining water on all
parts and fittings. Then engage the Trigger Safety Lock.
Use the included Wire Tip Cleaner (I) to help remove mineral deposits from the
nozzle. The more minerals that are dissolved in the water (the harder the water) you
use, the more often mineral buildup will need to be cleaned out from inside the
nozzle.
4. STORAGE: When storing, always completely empty the Pressure Washer of water.
Frost will damage the Pressure Washer if the unit contains water. Store the Pressure
Washer indoors in a dry, frost-free room. Minerals in the water can harden inside the
workings. Flush the unit with automotive antifreeze prior to long-term storage. Always
dispose of antifreeze in accord with local ordinances.
TIP CLEANER
(I)
KNOB (16A)
SPRAY LANCE (K)
FIGURE I