beautypg.com

Introduction, Important information – Hotpoint EG900X User Manual

Page 3

background image

3

Your new dual fuel cooker is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance
has been installed in accordance with the installation instructions detailed in this booklet.

To help make best use of your cooking equipment, please read this booklet carefully.

The appliance is designed specifically for domestic use and responsibility will not be accepted for use in any other
installation.

INTRODUCTION

To help remove the 'new' smell, heat the empty oven to maximum temperature for a minimum of two to three hours,
keeping the door closed. Ensure that the room is well ventilated (eg. open a window or use an extractor fan) and that
persons who may be sensitive to the odour avoid any fumes. It is suggested that any pets be removed from the room until
the smell has ceased.

This odour is due to any temporary finish on oven linings and any moisture absorbed by the insulation.

Note: When the oven is first used, an odour may be omitted - this will cease after a short period of use.

* The guarantee is subject to the provisions that the appliance:

(a) Has been used solely in accordance with this booklet.
(b) Has been properly connected to a suitable supply voltage as stated on the rating plate, attached to the
appliance.
(c) Has not been subjected to misuse or accident or been modified or repaired by any person other than the
manufacturers authorised employee or agent.
(d) Has been correctly installed.

IMPORTANT INFORMATION

- this appliance has been designed for private, non-

professional domestic use in the home.

- read this instruction book carefully, as it provides

important advice regarding safe installation, use and
maintenance. Keep the instruction book in a safe place
for future reference.

- the oven accessories that may come into contact with

food are made of materials which comply with the
provisions set forth by the EEC Directive 89/109 of 21/
12/88 and the applicable national norms in force.

- after removing packaging, check that the appliance is

intact. If in doubt, DO NOT use the appliance and contact
a qualified serviceman.

- some parts are covered with a removable scratch-proof

film. Before using the appliance, the film should be
removed and the underlying part cleaned with a cloth
and a non-abrasive household cleaning product.

- when switching the appliance on for the first time, we

recommend you heat the oven on maximum temperature
setting for about 30 minutes with nothing in it, to elimina-
te any residue from manufacture.

- all installation and adjustment operations should be carried

out by a qualified serviceman in accordance with the
applicable norms in force. Specific instructions are
provided within the installation section of this instruction
book.

- before connecting the appliance, make sure that the data

on the rating plate (situated underneath the appliance)
correspond to the mains electricity and gas supplies.

- check that the capacity of the electrical system and the

power outlets are suitable for the maximum power of the
appliance (indicated on the rating plate). If in doubt,
consult a qualified technical engineer.

- check the condition of the gas pipe regularly and have it

replaced by a qualified technical engineer as soon as it
shows any signs of wear or anomally.

- under no circumstances should the user replace the power

supply cable of the gas connection pipe of this appliance.
In the event of damage or the need for replacement,
contact an authorised service centre only (see Key
Contacts, back page).

- DO NOT leave the appliance plugged in if it is not in use.

Switch off at the mains electrical switch and turn off the
gas supply.

- During operation, the oven glass door and adjacent parts

of the appliance become hot. Make sure, therefore, that
children do not touch the appliance. For greater safety,
an additional child-safety device is available from our
Head Office and our Authorised Service Centres (see
enclosed list). When ordering this, please give the code:
BAB - followed by the appliance model. The model is
stamped on the rating plate affixed to the rear of the
appliance and at the back of this booklet.