Harbor Freight Tools 93601 - Manual (Page 5)

SKU 93601 For technical questions please call 1-800-444-3353. Page 5
Parts List
Part # Description Quantity
1 Flexible Hose, 4” x 10’ 2
2 Blast Gate-4” x 4” 2
3 Jointer Hood-6” 2
4 “Y” Fitting-4” x 4” x 4” 1
5 Table Saw Dust Hood 12” x 12” 1
6 Wire Hose Clamp 10
Inspection, Maintenance and Cleaning
1. CAUTION: Prior to performing any inspection, maintenance, or cleaning of the Dust
Collector Accessory Kit, make sure to turn OFF and then disconnect the power tool from the
outlet.
2. BEFORE EACH USE, inspect the general condition of the Dust Collector Accessory Kit.
Check for loose connections, misalignment or binding of moving parts, cracked, torn, or
broken parts, and any other condition that may affect its safe operation. If abnormal noise or
vibration occurs, have the problem corrected before further use. Do not use damaged
equipment.
3. DAILY: With a soft brush, cloth, or vacuum, remove all debris from the Dust
Collector Accessory Kit. If necessary, you may use a mild detergent.
4. Clean the hoses periodically by standing it on end and tapping it to remove dust and debris.
Parts Diagram
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
1
2
3
4
5
6