Hunter Fan 30180 User Manual

Page 3

43063-01 20100615

Figure 2 - Calendar Control

1. Clean the outside of the unit with a soft, damp

cloth. Figure 3.

2. At least every 90 days, open the front grill,

remove the carbon pre-filter, and replace it.

This is necessary to maintain proper odor-

removing and overall filtration performance.

If necessary, it can be changed more often.

Mark the new filter installation sticker

included with the new carbon pre-filter and

set the filter calendar dial. Be sure to remove

any plastic wrapping that may be on the new

filter before you place it into the Air Purifier.

3. Every 6 months you should remove the front

grill and check the HEPAtech filter to see if

it needs to be replaced. Compare the color

Filter Change Calendar: The filter counter is

designed to optimize the performance of the

air purifier by reminding you when to change

the HEPAtech Filter and pre-filter. It is located

around the speed control dial. See Figure 2.

HEPAtech Filter Calendar: The HEPAtech

Filter indicator is located in the center of the

calendar ring. To set the HEPAtech Filter

Pre-Filter Calendar

Filter Calendar

On/Speed

Control

Ionizer

Indicator

Ionizer

Figure 1 - Purifier Controls

Power

Indicator

ClEANINg ANd FIlTER REPlACEmENT

On/Speed Control: Rotate the Speed Control

knob to set the desired speed.

Unit off

Low speed - Recommended for

use when soft background noise

is unwanted.

Medium Speed - Typical usage setting.

Soft background noise is not an issue.

High speed - Use when quick, efficient

results to a room’s air quality are

desired.

The fan speed can be adjusted at any time.

Press the Ionizer button to turn on the Ionizer

function of your air purifier. The Ionizer Light will

glow while the Ionizer is activated.

NOTE: DO NOT run the ionizer if tobacco

smoke, air fresheners, dripless wax candles, or

grease from cooking is present.

OPERATINg YOUR AIR PURIFIER

counter, rotate the calendar ring to align the filter

symbol ( ) with the month that you installed the

filter. Since the filter is designed for 6 months

use, the second indicator ( ) will serve as a

reminder to check the filter every 6 months. If

the HEPAtech filter ( ) is checked in April, then

the filter would need to be checked again ( ) in

October.

Pre-filter Calendar: The outer knob of the

filter calendar is the pre-filter counter. To use,

align the pre-filter symbol ( ) on the ring with

the month that you installed the pre-filter. The

replacement symbol ( ) on the outer knob

points to the month in which you should install

a new pre-filter. The pre-filter is designed for 3

months of usage. Replacing the pre-filter ( ) in

July means the filter would need to be replaced

again ( ) in October.