Harbor Freight Tools Creeper With Adjustable Headrest 46087 - Manual (Page 3)

9. use the right tool for the job. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. Do not modify this tool and do
not use this tool for a purpose for which it was not intended.
10. stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired.
11. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and binding
of moving parts; any broken parts or mounting fixtures; and any other
condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician.
12. replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are
available from Harbor Freight Tools.
13. do not operate Creeper if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the creeper.
14. Maintenance. For your safety, maintenance should be performed
regularlyby a qualified technician.
warning: the warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations
that may occur. it must be understood by the operator that common
sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.
unpacking
When unpacking, check to make sure the parts listed on page 4 are included. If
any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
SKU 46087 Page 3
Operation
1. If you raise the vehicle to work under it, set the vehicle on jack stands. Do not
work under a vehicle raised on a jack. If the vehicle is on the ground, block the
tires, set the parking brake, and put it in gear or Park.
2. Adjust the headrest using the
adjustment lever (#5) down to 0 degrees.
Keep your head flat on the head Cushion (#4) while you slide under the vehicle,
then adjust the head Cushion (#4) to a comfortable angle.
3. Lower the head Cushion (#4) to 0 degrees to slide the Creeper out.