Hampton Direct H300 - Manual (Page 18)

Hampton H300 Cast Freestanding Woodstove 18
CAUTION: Label all wires
prior to disconnection
when servicing controls.
Wiring errors can cause
improper and dangerous
operation.
WARNING: Electrical Grounding
Instructions
This appliance is equipped with
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
An optional blower is available for the Hampton
H300. The blower is factory assembled, wired
and ready for attachment to the stove.
This unit must be connected to a grounded,
standard 120 volts, 60 Hz electrical outlet.
Never route the power cord under or in front
of the unit.
Do not under any circumstances, cut or remove
the grounding prong from the power cord. Do
not use an adaptor plug.
CAUTION: Moving parts may cause injury.
Do not operate unit with blower housing
removed.
DANGER: Risk of electric shock. Discon-
nect power before servicing unit.
NOTE: For more detailed information see
instructions included with the Optional
Blower.
6) Loosen the 2 bolts you see after removing
the fan cover plate. One on each side of
unit.
7) Hook fan over bolts.
8) Tighten bolts to secure fan.
9) Reinstall back shield.
10) Using the 3 screws from the fan cover
plate, secure the fan assembly to the back
shield.
11) Plug-in power cord.
12) Place top back on.
Right Side
Bolt
OPTIONAL BLOWER / FAN INSTALLATION
1) Lift off top.
2) Place left and right side air channels on
fi rebox top as shown below.
Right Side
Air Channel
Shown
3) Secure each air channel with one screw.
Left Side
Air Channel
Right Side
Air Channel
4) Remove back shield by undoing 2 screws.
5) Remove fan cover plate from back shield
by undoing 3 screws.
Ground
Fan Fan
Ground
Green
Neutral
Live
White
Fan
Switch
Manual/
Auto
Switch
Black Black High
(Black)
Low
(Red)
Black
Fan Thermodisc
(normally open)
120V AC
60 Hz
Blower/Fan Wiring Diagram
Secure
with screw.
Screws
NOTE INPUT POWER: Australia, New Zealand,
China and Japan use 240V AC 50 Hz.
INSTALLATION