Harbor Freight Tools CENTRAL HUDRAULICS 65549 - Manual (Page 3)

SKU 65549 For technical questions, please call 1-800-444-3353. Page 3
specIFIcatIons
Air Pressure 120 PSI
Maximum Compression 2200 lbs.
Ram Travel 12.8"
Coil Spring Sizes Accepted 4" Dia. to 6.3" Dia.
Spring Length Accepted 5" Long to 18" Long
Shoes
Small Set (4" Springs)
Large Set (6.3" Springs)
unpackInG
When unpacking, make sure that the item
is intact and undamaged. If any parts are missing
or broken, please call Harbor Freight Tools at the
number shown on the cover of this document as
soon as possible.
asseMblY precautIons
Use only according to these instructions. 1.
Improper use can create hazards.
Wear ANSI-approved safety goggles and
2.
heavy-duty work gloves during use.
Keep work area clean and well lit.
3.
Keep bystanders out of the area during use. 4.
Do not use when tired or when under the 5.
influence of drugs or medication.
IMportant saFetY
InForMatIon
In this manual, on the labeling, and all
other information provided with this
product:
this is the safety alert symbol.
It is used to alert you to potential
personal injury hazards. obey
all safety messages that follow
this symbol to avoid possible
injury or death.
danGer indicates a
hazardous situation
which, if not avoided,
will result in death or serious injury.
WarnInG indicates a
hazardous situation
which, if not avoided,
could result in death or serious
injury.
cautIon, used with
the safety alert symbol,
indicates a hazardous
situation which, if not avoided,
could result in minor or moderate
injury.
notIce is used to
address practices not
related to personal
injury.
cautIon, without the
safety alert symbol, is
used to address
practices not related to personal
injury.
General saFetY.
WarnInG! 1. Ensure Health & Safety, local
authority, and general workshop practice
regulations are adhered to when using this
equipment.
WarnInG!
2. Wear approved safety hand and
eye protection (standard spectacles are not
adequate).
WarnInG! trappInG danGer
3. ─ Keep
hands and fingers away from the spring and
compressing Shoes when in use.
Keep the work area clean, uncluttered and
4.
ensure there is adequate lighting.
Maintain correct balance and footing. Ensure
5.
the floor is not slippery and wear non-slip
shoes.
Remove ill-fitting clothes. Remove ties,
6.
watches, rings and other loose jewellery.
Contain and/or tie back long hair.
Wear appropriate protective clothing.
7.
Familiarize yourself with the applications, 8.
limitations and potential hazards of the
Spring Compressor.
do not
9. force the spring compressor to
achieve a task it was not designed to per-
form.
do not
10. allow untrained persons to use the
spring compressor.