Maintenance and servicing – Harbor Freight Tools 99621 User Manual
Page 6
SKU 99621
For technical questions, please call 1-800-444-3353.
Page 6
Empty the Hopper Assembly and
9.
re-weigh the material. By taking note
of how much material you used and
how wide the spreading area was,
you can figure the correct rate of
spread. This will help you maintain
the correct spreading rate for your
project.
To prevent accidents, turn off the ATV
10.
and disconnect the ATV Spreader
after use. Clean, then store indoors
out of children’s reach.
mAintEnAncE AnD
SERVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
to PREVEnt
SERiouS injuRy
FRom AcciDEntAl
oPERAtion:
turn the Power Switch of the
vehicle to its “oFF” position
before performing any
inspection, maintenance, or
cleaning procedures.
to PREVEnt SERiouS
injuRy FRom tool
FAiluRE:
Do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
cleaning, maintenance, and
lubrication
bEFoRE EAcH uSE,
1.
inspect the
general condition of the ATV Spread-
er. Check for loose screws, misalign-
ment or binding of moving parts,
cracked or broken parts, damaged
electrical wiring, and any other condi-
tion that may affect its safe operation.
AFtER uSE,
2.
clean external surfaces
with clean, moist cloth.
Clean out the Hopper Assembly and
3.
using a shop vacuum (not supplied),
clear all leftover material from the
Turning Plate (16) and other areas of
the Spreader.
Rinse the ATV Spreader with a hose
4.
and fresh clear water. Let dry before
storing indoors away from children.
notE:
5.
If the ATV Spreader is to be
left outside between jobs, always
cover with the Rain Cover (1) to
protect both the Spreader and any
material that may be in the Hopper
Assembly (8).
PlEASE READ tHE FolloWing
cAREFully
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND ASSEMBLy
DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLy. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANy REPRESENTATION
OR WARRANTy OF ANy KIND TO THE BUyER
THAT HE OR SHE IS qUALIFIED TO MAKE ANy
REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS qUALIFIED TO REPLACE ANy PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR ExPRESSLy STATES
THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN By CERTIFIED AND
LICENSED TECHNICIANS, AND NOT By THE
BUyER. THE BUyER ASSUMES ALL RISK AND
LIABILITy ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS
THERETO.