Lint filter, Safety lid switch – haier ESL-T21 User Manual

Page 14

Text mode
Original mode

English

Lint Filter

• The lint filter must be used during washing.
• It must be cleaned in time after each using.

1. Take off the lint filter.

Pull up the lint filter from the agitator.

2. Remove lint

Press the lint screen clip with your thumb and index finger, and get the screen
downward as shown in figure below. While wet, remove the lint from the screen.

3. Install the lint filter

After cleaning, install the screen back onto the lint filter. Then put the lint filter
back in the agitator barrel.

Safety Lid Switch

• If for any reason you open the lid in the middle of the wash cycle, the

washer will not spin and will shut off automatically. Once the lid is
closed, the washer will start back on.