HSM 411.2 - Manual (Page 11)

HSM 411.2 Paper shredder
0603 english 11
5. Start-up
Switching the paper shredder on
• Set mains switch at rear of paper
shredder to „I“.
• Paper shredder is ready for ope-
ration when green LED on control
panel lights.
Notice
Safety switches are installed at
the door and inspection door.
Paper shredder can only be
switched on if the door and the
inspection door are both closed.
Shredding paper:
• Feed paper into the paper infeed
opening (see „Technical data“ for
sheet capacity)
• The shredding pro cess is star-
ted by a pho to –cell in the paper
feeding opening
• App rox. 3 sec. af ter the last sheet
of paper is pulled in the cut ting
sy stem au to ma tical ly swit ches off
and returns to standby.
The document shredder can also
be started by pressing the green
arrow button:
• Press briefl y:
Cutting device starts.
Automatic stop approx. 3 se-
conds after the last piece of pa-
per was drawn in, or manual stop
when the stop button is pressed
• Hold down for longer than 2
seconds: constant operation
without light barrier function.
The cutting device runs until it is
switched off with the stop button.
0
I
0
I
Switching the paper shredder off
• Set mains switch at rear of paper
shredder to „0“.
Destroying credit cards, CDs, discs or
DAT cassettes:
Cross cut machines:
Fold the safety element down (only for cut-
ting types 3.9 x 50 mm and 1.9 x 15 mm),
switch the machine on to continuous opera-
tion and feed the material into the insertion
slot.
only for cutting type
3.9x50 mm
DAT cassettes
For strip cut machines, feed the CDs, credit
cards or discs directly into the paper feed
slot.
only for cutting type
3.9x50 mm 3.9x50 mm • 1.9x15 mm
Floppy disks Credit cards • CDs