Hotpoint EW34 - Manual (Page 38)

38
Care and Cleaning
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass that is coated
with a heat reflective layer. Do not use scouring pads, or abrasive powder, which will
scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical
blows.
Stubborn stains can be removed by using a fine steel wool pad. For slight soiling the inner glass
panel may be cleaned, while still warm, without removing it from the door. After cleaning, rinse
and dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take care to support
the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows:
1. Open the door fully
2. Press and release the left and right hand
door trim mouldings, the release button is
situated between the inner and outer door
glass at the top of the door trims.
Carefully lift the door trim top moulding and
remove the inner glass from the door trim
bottom mouldings.
Ensure that the door is not allowed to slam
shut due to the reduction in door weight.
Clean the glass as described above.
3. Hold the door open. The inside of the door outer glass can now be cleaned, taking care the
door does not slam shut trapping fingers.
Refit the door inner glass as follows:
1. Open the door fully.
2. Locate the door inner glass into the door trim bottom mouldings.
Ensure the printing is readable from the face nearest the oven (NB. printing MUST be
positioned at the bottom of the door).
3. Carefully re-locate the door trim top mouldings back into position.
Ensure the door inner glass is now held in place by the top and bottom door mouldings
and cannot fall out.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
Door trim moulding
release buttons