Harbor Freight Tools One Stop Gardens Stainless Steel Solar Lights 92122 - Manual (Page 3)

Page 3 SKU 92122 For technical questions, please call 1-800-444-3353.
SpeciFicationS
Battery Ni-cd, AA 1.2V, 600mAh (included)
Included 2 Stainless Steel Solar Lights
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please call
Harbor Freight Tools at the number shown
on the cover of this manual as soon as
possible.
initial Set up
inStructionS
read all warning sections at the
beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unscrew the lens of the Head
1.
Fixture. Remove the four screws on
the bottom of the Fixture. Open the
battery compartment to verify that
battery polarity is correct. Be careful
not to pull on the wires connected to
the casing, damaging the wires will
render the unit dysfunctional. Close
the unit and replace the screws.
Push the power switch to the ON
2.
position. Replace the lens.
Examine the area where the Solar
3.
Light is to be placed. Make sure
there are no utility lines beneath the
surface that might be damaged. For
best results, the Lights should be
placed in an area that receives at
least eight hours of direct sunlight per
day.
Place a Spike onto a Connector and
4.
then into the Shaft.
Push the unit firmly into the ground.
5.
The Solar Light can be placed on the 6.
Shaft now.
Repeat these steps to assemble the
7.
other light.
operating inStructionS
Allow the Light to charge for a full 1.
day in direct sunlight, before first use.
note: The on/off switch must be in
the ON position when charging.
The Solar Light will turn on
2.
automatically when it gets dark, and
provide illumination for up to eight
hours.
Do not install the Solar Light near a
3.
nighttime light source. A bright light
source will prevent the Light from
turning on at night.
To store the unit, turn off the Light
4.
and disconnect its power supply after
use. Clean, then store the Light
indoors out of children’s reach.