Husqvarna 1130ST - Manual (Page 9)

9
OPERATION
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power-
propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Discharge chute control lever - used to change the
direction the snow is thrown.
Deflector remote control lever - used to change the
distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the
ground.
Drift cutter - used to cut through deep snowdrifts.
Toolbox - used to store spare shear bolts, locknuts, wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or
SLOW engine speed and to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE CONTROL LEVER
RECOIL
(AUXILIARY)
STARTER
HANDLE
THROTTLE /
ENGINE
CONTROL
DEFLECTOR REMOTE
CONTROL LEVER
DRIVE SPEED
CONTROL LEVER
AUGER
CONTROL
LEVER
MUFFLER
TOOLBOX
HANDLE
KNOB
LH TURN
TRIGGER
SKID PLATE
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
AUGER
GASOLINE
FILLER
CAP
ENGINE OIL CAP
WITH DIPSTICK
SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
ELECTRIC
START
BUTTON
PRIMER
FUEL SHUT-OFF VALVE
NOTE: ITEMS
ABOVE ARE
SHOWN IN THEIR
TYPICAL LOCATION
ON THE ENGINE.
ACTUAL LOCATION
MAY VARY WITH
THE ENGINE ON
YOUR UNIT.
LIGHT
OIL DRAIN
PLUG
POWER
CORD
PLUG
DRIFT CUTTER