Husqvarna 125BT - Manual (Page 16)

16 – English
MAINTENANCE
Maintenance schedule
Below you will find some general maintenance instructions. If
you need further information please contact your service
workshop.
Daily maintenance
1 Clean the outside of the machine.
2 Check that the throttle control functions safely.
3 Check that the stop switch works correctly.
4 Clean the air filter. Replace if necessary.
5 Check that nuts and screws are tight.
6 Check that there are no fuel leaks.
Weekly maintenance
1 Check the starter and starter cord.
2 Check that the vibration damping elements are not
damaged.
3 Clean the outside of the spark plug. Remove it and check
the electrode gap. Adjust the gap to 0.5/0,6 mm or replace
the spark plug.
4 Clean the cooling fins on the flywheel.
5 Clean or replace the spark arrestor mesh on the muffler
(only applies to mufflers without a catalytic converter).
6 Clean the carburettor compartment.
7 Clean the cooling fins on the cylinder and check that the
air intake near the starter is not blocked.
Monthly maintenance
1 Clean the fuel tank.
2 Clean the outside of the carburettor and the space around
it.
3 Clean the fan and the area around it.
4 Check the fuel filter and the fuel hose. Replace if
necessary.
5 Check all cables and connections.
6 Replace the spark plug.
7 Check and clean the spark arrestor mesh on the muffler
(only applies to mufflers fitted with a catalytic converter).
1 2 3
4 5 6
4
7 6
2 3
5
1
4
7 6
2 3
5
1