Harbor Freight Tools 41345 - Manual (Page 2)

Warning:
1. Read this instruction manual completely before using the Self Centering Doweling Jig.
2. Always wear ANSI approved safety goggles when working with tools and equipment. Wear a full face
shield if you are producing wood chips.
3. Keep children out of the work area. When not in use, store this product in a location that is out of reach
of children.
4. Keep work area clean. Cluttered areas invite injuries.
5. Observe work area conditions. Do not use tools in damp, wet, or poorly lit locations. Don’t expose to
rain. Keep work area well lit.
6. Do not force the tool. It will do the job better and more safely at the rate for which it was intended. Do
not use inappropriate attachments in an attempt to exceed the tool’s capacities.
7. Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Non-skid
footwear is recommended. Wear restrictive hair covering to contain long hair.
8. Stay alert. Watch what you are doing. Use common sense. Do not operate any tool when you are tired.
Direction for Use:
1. Line up the two boards that are to be connected by the dowels. On the side of each
board, draw a vertical mark to show where the dowels are to be located (see illustration
below).
2. Separate the two boards,
and clamp the Doweling Jig
over the edge of one of the boards.
Align the mark on the board
with the desired dowel diameter
(see hole sizes in Guide Block).
Insert appropriate bushings before
drilling the dowel hole to the depth
desired. The drilled hole will be
exactly in the center of the board edge.
Vertical Marks To Show
Dowel Location
Square Edge
Top Board
Bottom Board
#41345 Page 2