Hotpoint RL175X - Manual (Page 4)

4
GB
Stability bracket
WARNING: To prevent the fridge from tilting forwards, it
must be held in place with the stability bracket supplied.
This is the responsibility of the customer.
Fixed to the floor or wall at the rear of the fridge, the
stability bracket hooks onto the compressor mounting
plate holding the fridge secure.
The stability bracket must be installed securely in
accordance with these instructions BEFORE using
the fridge.
Note: The fridge is heavy so care must be taken
when moving it.
1. Position the fridge in its chosen location.
2. Looking from the front of the fridge, mark the position of
the left hand panel.
3. Move the fridge far enough away to get clear access to
the back wall.
4. In order to clear components on the compressor
mounting plate, the stability bracket must be positioned
on the floor between 100 - 200mm to the right of the left
hand panel mark.
5. Mark and drill the fixing holes and insert suitable fixings
to hold the bracket firm.
6. Carefully re-position the fridge. Make sure that the
compressor mounting plate locates into the stability
bracket.
Position stability racket
100 - 200mm away from left
hand panel mark.
Position of left
hand panel