Harbor Freight Tools One Stop Gardens 8' x 10' Greenhouse with Two Vents 93920 User Manual
Page 14
Page 14
SKU 93920
For technical questions, please call 1-800-444-3353.
Orient the assembled door frames for so that the Outer Door Frame (27a) is on the
3.
left, and the Inner Door Frame (27b) is on the right. This is the assembly used for
the left door, the right door will be assembled later with the Outer and Inner Door
Frames on the opposite sides (outer on right, inner on left). All illustrations show
the left door assembly.
Attach the Top Door Frame (30) to the top of the Outer/Inner Door
4.
Frames (27a, 27b). Make sure that the rounded portion faces
the front and that the flange where the pane will sit faces down
towards the center of the door, see the diagram to the right.
Using two Short Bolts (59) and two Nuts (61), attach the Door
5.
Slider (29) to the Top Door Frame (30) with the rollers on the top
of the door.
Insert a Door Bottom Slider (64) into each end of the Bottom Door
6.
Frame (32). Make sure that the Sliders are assembled the correct
way, with the gap facing the back of the door – see diagram to
the right. Attach the Bottom Door Frame (32) to the Outer/Inner
Door Frames (27a, 27b) using two Screws (57) on each side – the
one on the top into the Bottom Door Frame (32) and the bottom
one into the Door Bottom Slider (64).
Raise the assembled Door up and insert the first roller of its Door
7.
Slider (29) onto the Door Rail (28). Carefully align the first Bottom
Door Slider (64) over the edge of the Front Floor Plate (17) – see
illustration to the right. Carefully slide the door over and align the
other top Roller and bottom Slider as you did the first ones.
Assemble and install the right door by following the preceding
8.
steps, except place the Outer and Inner Door Frames (27a, 27b) on the opposite
sides as explained in step 3.
Once both doors are installed, install a Short Bolt (59) and Nut (61) into the hole
9.
on the ends the Door Rail (28) to prevent the doors from sliding off the rails. Attach
the Right and Left Rail End Caps (70,71) onto the ends of the Door Rails.
27a
30
PANE
27b
32
64
57