Husky 1550 PSL User Manual

Page 21

HUSKY 1550

PROBLEM OR CONCERN POSSIBLE CAUSE

SOLUTION

No water coming out of
Wand

Gun/Hose Assembly is defective Attach the Gun/Hose to the front of the unit with

no wand attached to the Gun.
Squeeze the trigger of the gun to ensure that water
comes out of the front of the Gun at a rate equal
to the Garden Hose. If no water comes out of the
Gun, remove the gun and the hose to ensure that
water flows out of the pump. If it does, the gun will
need to be replaced. Contact us at:
[email protected]
or order a replacement directly online at:
www.huskypowerwasher.com

Trigger will not move

Gun Safety Lock in engaged

Release Safety Lock as instructed in Manual.

Unit will not start

Note: Unit will only start when
trigger is depressed.

Unit stops while operating

Unit is not turned on

Press ON/OFF Switch into ON position.

Loose or disconnected Plug

Reconnect Plug.

Defective GFCI Plug

Perform GFCI reset procedure as instructed in
Section 4.3. If the GFCI does not reset it will
need to be replaced. Contact us at:
[email protected]
or order a replacement directly online at:
www.huskypowerwasher.com

Extension Cord length or gauge
incorrect

Use proper Extension Cord as instructed in section
4.3.

Gun trigger not operating
properly

Defective Gun

Remove the Gun and Hose assembly from the
front of the unit. Aim water stream away from
electric source and switch the unit into the ON
position. If the unit starts and water comes out
of the front, the Gun may need to be replaced.
Contact us at:
[email protected]
or order a replacement directly online at:
www.huskypowerwasher.com

Tripped Pressure washer
Thermal Switch

Allow to cool and restart unit.

Defective ON/OFF Switch

Unit will not stop when trigger
is released

Screen filter is clogged

Clean the Screen filter as instructed in the section
6.4.

Garden Hose is kinked or
leaking water

Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.