Harman-Kardon 950-0321-001 - Manual (Page 12)

BDS
12
Mounting Options for Satellite and Center Speakers
Attach the wall portion of the wall-mount bracket onto the wall using hardware that is 4.
appropriate for the wall’s construction and materials. We recommend first anchoring the
bracket using its keyhole, then attaching it with another anchor through its top opening,
as shown in the illustration. The satellite speakers weigh 3.3 lb (1.5kg). Be sure to use
hardware that can support this weight.
Top Opening
Keyhole Opening
Bottom Opening
NOTE: If you’re running the speaker wire through the wall, you can bring it out directly behind
the bracket location and insert it through the bottom opening in the wall portion of the
bracket, as shown in the illustration. This move will keep the wire completely hidden from
view once the installation is complete.
Insert Wire into
Bottom Opening
Bring Wire Out
Through Here
If you’re not running the speaker wire through the wall, insert it through the wall portion 5.
of the wall-mount bracket as shown in the illustration.
Pass the speaker wire through the speaker portion of the wall-mount bracket as shown 6.
in the illustration.
Bring Wire Out
Through Here
Bring Wire In
Through Here
If you have not already removed the speaker’s base, do so by pulling it straight off the 7.
speaker, as shown in the illustration. Applying even pressure to both sides of the base
will allow it to slide off smoothly.
Apply Pressure Evenly to Both
Sides of Base Lift Base Straight off Speaker
CAUTION: Before making speaker connections, be sure that the BDS receiver is
turned OFF and, preferably, its AC cord is unplugged from the AC outlet.
Connect the speaker wire to the speaker terminals as shown in the illustration: 8.
+
–
A. Push Down on Cap
to Open Hole
B. Insert Bare Wire
into Open Hole
C. Release Cap
to Secure Wire
Colored Band
to Red Terminal
IMPORTANT: Make sure the (+) and (–) bare wires do not touch each other or the other
terminal. Touching wires can cause a short circuit that can damage your receiver or amplifier.
Slide the speaker portion of the wall-mount bracket onto the speaker as shown in the 9.
illustration below. Fit the grooves on the bracket onto the rails in the speaker, and apply
even pressure on both sides of the bracket so it slides straight onto the speaker.
Push the bracket all the way onto the speaker until it snaps into place. t
Pull any slack speaker wire back through the bracket as you slide the bracket onto the t
speaker.
Fit Bracket Grooves
onto Speaker Rails
Push Down Evenly on
Both Sides of Bracket
Slide the speaker onto the bracket’s wall section as shown in the illustration. Pull any 10.
slack speaker wire back through the bracket’s wall section.
Slide Speaker
onto Bracket
Fit the metal stop plate into the recess on the bottom of the bracket with the pad facing 11.
the bracket, and fasten it to the bracket using two of the supplied screws. Fastening it
will prevent the speaker from detaching from the bracket and will hold the speaker’s
position as you rotate it on the mount.
Stop Plate
Supplied Screws