Harbor Freight Tools 95630 - Manual (Page 9)

Page 9 For technical questions, please call 1‑800‑444‑3353. SKU 95630
Assembly
Read the ENTIRE
IMPORTANT SAFETY
INFORMATION section at the
beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.
1. Connect one end of the air hose to the
Air Outlet (38).
2. Connect other end of air hose to the Air
Brush (27).
3. Inspect the air connections for leaks.
Repair any leaks found.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Route the air hose along a safe route to
reach the work area without creating a
tripping hazard or exposing the air hose
to possible damage. The air hose must
be long enough to reach the work area
with enough extra length to allow free
movement while working.
3. Secure loose workpieces using a vise
or clamps (not included) to prevent
movement while working.
4. There must not be hazardous objects
(utility lines or foreign objects) nearby
that present a hazard while working.
General Operating Instructions
1. Choose a 120V power supply and plug in
Air Compressor.
2. Set the Pressure Gauge to desired air
pressure (maximum 58 PSI).
3. Fill the 22cc Glass Jar (31A) after
thinning your paint properly.
NOTE: Use the proper solvent for thinning.
Use lacquer thinner for all lacquers, paint
thinner for oil based paints, and water for
all latex based paints.
4. Hold the Air Brush Housing (8A) lightly
in your hand and push the tappered
fitting on the lid of the 22cc Glass Jar
Assembly (31A) into the base of the Air
Brush Housing (8A). It is held in place
with friction and not threading.
5. Turn on the Power Switch (34) and
the Air Compressor will start and
work continuously until it reaches its
maximum preset pressure which will
be approximately 55 PSI at which time
it will automatically shut down. It will
re-start when the pressure drops to
approximately 42 PSI.
6. By pressing the Finger Lever (10A)
air will emerge from the Nozzle (3A).
Draw back slowly/gently on the Finger
Initial Tool Setup/Assembly
Operating Instructions