Husqvarna 544 93 62-01 - Manual (Page 9)

SpeedMill 9
OPERATION
Rotate Pipe and repeat this cut-
ting process until pipe circum-
ference is cut.
WARNING!
HOLD MACHINE ONLY at front and rear handles!
NEVER bevel or cut material while holding the pipe with
your hands!
DO NOT use blade guard pivot handle as a hand hold
while operating machine!
Align proper SpeedMill Bowl
with end of pipe, and move
toward the pipe so that the pipe
is slightly beveled.
Note: The bevel required is
usually quite small, so do not
remove excessive pipe mate-
rial.
Bevel Pipe: Position SpeedMill
Bowl near end of pipe to be
beveled. Accelerate power cut-
ter to full throttle.
HOLD MACHINE ONLY at front and rear handles, as shown in
the above photo.