Haan QUICKPRO TS-30 - Manual (Page 9)

www. HAANUSA.com 877-HAAN DIRECT / 877-422-6347 pg 7
Using Your QuickPro ™ Portable Steamer & Sanitizer
Operating Instructions:
1) Remove all parts from the packaging.
2) Set the HAAN
®
QuickPro ™ on the Metal Resting Tray. Do not
plug the unit in while adding water to the reservoir.
3) Remove the Water Reservoir by pressing the Quick-Release Tabs
(Fig 1) on both sides of the appliance. Hold them in as you
pull the Water Reservoir out of the rear of the appliance main
body (Fig 2).
NOTE: The HAAN
®
QuickPro ™ has been designed to operate using
untreated tap water. If the water being used is very hard (check
with your local water authority) it could leave mineral deposits
inside the appliance that can build-up over time and interfere
with the function of the unit. Is possible to mix the tap water
with distilled water in the following proportions to help reduce
mineral build-up within the appliance and prolong the lifespan
of your Portable Steamer & Sanitizer.
• 50% untreated tap water with 50% distilled or
demineralized bottled water
4) Once removed from the main body, turn the Water Reservoir
up to show the grey stopper. (Fig 3)
5) Grasp the tab on the stopper and gently pull the stopper out
(Fig 4). Remove it only enough to allow for adding water.
DO NOT break the connecting elastic band.
6) Add water to the reservoir thru the stopper hole until the
reservoir is full. Do not overfill. Carefully replace the stopper
and close it securely aligning the tab as shown (Fig. 3).
7) Replace the Water Reservoir into the main body of the appliance.
With the Quick-Release tabs at the inner bottom, slide the
Water Reservoir in until the tabs clip securely (Fig 1).r
Fig 1
Quick-
Release
Tab
Fig 2
Hold
and
pull
out
Fig 3
Water
Reservoir
Stopper
Fig 4
Water
Reservoir
Stopper
Tab