English – haier HDF05WNAWW User Manual

Page 10

Reinstallation:

(see fig. # 4 and fig. # 5)

1. Remove the lower pivot pin from the bracket of the lower

hinge by turning counter clockwise. Move the pin to the
opposite hole and tighten.

2. Loosen the screws holding the lower hinge bracket

and remove the hinge.

3. Align the holes in the lower hinge bracket to the

corresponding holes in the opposite side of the cabinet.
Insert and tighten the screws.

4. To install refrigerator door: make the left bottom hole of the

refrigerator compartment door fall over the lower hinge axle, move
door forward to make it straight and in alignment with central hinge.
Install the central hinge again, turn the hinge axle until it
completely enters the door body, then fix it with screws.

5. To install freezer door: make the left bottom hole of freezer door fall

over the central hinge axle; raise upper hinge, so that hinge axle can
be installed in the upper hole of the upper part of the freezer door;
adjust door to make it straight and level.

6. As shown in Fig. 1, install the upper freezer hinge to the left

corresponding position. (tighten the screws of upper hinge)

7. Replace the hinge cover as shown in Fig. 1.

middle pivot pin

middle bracket
(central hinge bracket)

screw holes

lower bracket

lower pivot pin

bottom hinge pad

fig. # 4

English

lower pivot pin hole

fig. # 5

English