Hamilton Beach 840129100 - Manual (Page 4)

7 6
Features
Auto Shutoff Reset Button/Light
This light comes on when the iron is first
plugged in. After 15 minutes, the iron will shut
off and the light will go out. Push the Reset
Button to turn the iron back on.
Power On Light
The light stays on even if Temperature Control Dial is turned to Off.
Adjustable Steam Control
This control provides minimum steam
for wool or maximum steam for linen.
Set the control to 0 (Dry Iron) setting
to iron without steam.
Caring and Cleaning
Iron Storage
1. The water tank of your iron should be emptied after each use.
Turn Temperature Control Dial to Off. Unplug the iron and hold
over a sink. Slowly tilt pointed end of iron down over sink. Water
will run out of water tank opening.
2. After iron has completely cooled, wrap cord loosely around
iron and store in an upright position. Do not store iron laying
flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as these may
scratch the soleplate.
2. To clean occasional build-up on the soleplate, wipe with a sudsy
cloth. Do not use abrasive cleansers or metal scouring pads.
3. Always store iron upright in the heel rest position.
Self-Clean
To maintain optimum steam performance of your iron:
Rotate the adjustable steam control from 0 to 4 several times to
remove debris and minerals from the steam valve.
Blast of Steam and Spray Buttons
Push Blast Button for an extra blast of
steam. Push Spray Button to release a fine
spray of water for difficult wrinkles in cotton
or linen.
Blast Spray
Light
Button
840129100 Comm_IronEv01.qxd 7/14/04 2:40 PM Page 6