haier HWM50-10 - Manual (Page 17)

(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending it to
repair. If there are real breakdowns, please come to the special maintenance department or
after-sale service department of our company. Do not repair it by yourself.
Phenomena The reason How to settle
The top lid is not closed.
Is the drain hose put down?
Is the drain hose blocked
by foreign material?
Are the laundries put
slantingly?
Are the laundries slanting in
spinning?
Is the machine slanting?
Is the machine slanting?
The water tap is not open
The water inlet valve is blocked
Is there power failure?
Is the power plug loose?
Is the jointer screw of the water
inlet hose is loose or twisted
awry? The water faucet leaks.
There's abnormal sound
inside the machine.
The machine
does not act.
Close the top lid.
Put down the drain hose.
Open and close the top lid once.
Clean the foreign material.
Open and close the top lid once.
Re-order the laundries. Close the
top lid.
Level the machine in right position.
Open and close the top lid once.
Open the water tap. Push the
"Start/Pause" button.
Clean the water inlet valve.
Push the "Start/Pause" button.
Wait for the normal water pre-
ssure before use.
Use it when the power is on.
Insert the power plug tightly.
Level the machine properly.
Re-order the laundries.
Fasten the jointer screw
properly.
Trouble shooting Answer to question
Does the water level arrive at the
set water level?
Affusion to the set water level.
Is the power plug loose? Insert the power plug tightly.
Is the top lid closed? Close the top lid.
Are the laundries put orderly? Put the laundries orderly.
Not spin
Not wash
Buzzing upon reservation starts,
Nixie tube indicates "E0".
Safety switch actuates, not spin,
(after self-correction twice),
nixie tube displays "E3", buzzing.
No or slow water filling not
reaching the level in 15min ,
nixie tube indicates "E4",
buzzing.
No or slow drain, nixie tube
indicates "E1" , buzzing.
If the nozzle is choked with
foreign bodies. Remove the foreign bodies.
Poor or no waterfall flow.
The top cover leaves open. Close the top lid.
Running pauses , nixie tube
indicates "E2", buzzing.
It is the water remained in the factory inspection of
performance.
Common phenomena
Phenomena Explanation
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is
needed before it starts spinning.
To prevent splash during water filling.
The spinning is intermittent when it starts.
While water filling in wash and rinse, the
pulsator pauses rotation
There may be some water flowing out of
the drain hose in the first use of the machine.
Push the "Procedure selection" button to
select "Spin", but it doesn't work.
Supplementary water filling 48 s after
sensor tests cloth material.
Wash pauses
The water pressure is too
low and the current is
too small.
15