Maintenance 60 – HONDA HR215SXA User Manual
Page 62

5. While holding the drive clutch
lever all the way forward, look
through the clutch cable
grommet in the mower deck,
and check the position of the
control arm.
The center of the notch on the
control arm should align with
the index mark on the
transmission case.
6. If adjustment is necessary,
loosen the drive clutch cable
lock nuts with a 10 mm wrench,
and move the adjuster up or
down as required. Tighten the
lock nuts. Operate the clutch
lever several times, and
recheck control arm alignment.
7. After the control arm is
precisely aligned, start the
engine and operate the drive
clutch lever. Check to be sure
the drive clutch lever operates
properly.
If the drive clutch lever does not
operate properly after the cable
is correctly adjusted, take the
mower to an authorized Honda
servicing dealer for repair.
CONTROL
ARM
NOTCH
CLUTCH
CABLE
GROMMET
TRANSMISSION CASE
LOCK NUTS
ADJUSTER
MAINTENANCE
60