Humminbird VHF5 - Manual (Page 11)

11
MEMORY CHANNELS
USING MEMORY CHANNELS
The VHF5 has 10 memory locations (00-09), to quickly access
frequently used channels.
To access the memory channels, press the MEMO/M.PRG button.
The LCD displays the channel number on the left, and the memory
location in smaller numbers to the right. Turn the CHL/SQL knob to
select a memory channel. To exit the memory channel mode, press
the MEMO/M.PRG button again.
Programming Memory Channels
To enter channels into memory:
1. Press the MEMO/M.PRG button.
2. Press and hold the FUNC button then press the MEMO/M.PRG
button. The memory location number begins to flash.
3. Rotate the chl/sql knob to the desired memory location.
4. Press the MEMO/M.PRG button. The channel number
begins to flash.
5. Press the BAND/HI/LO button to select either the USA, Weather,
or International band for the channel you wish to store.
6. Rotate the CHL/SQL knob to the desired channel for this
memory location.
7. Press and hold the FUNC button then press the MEMO/M.PRG
button to save the memory location and exit programming.
8. To store additional memory channels, repeat the above
procedure.
Press the MEMO/M.PRG button to exit the memory channel mode.
Scanning Memory Channels
To scan the memory channels, press the MEMO/M.PRG button,
then press and hold the SCAN/DUAL button for a few seconds.
SCAN appears on the LCD as the radio scans the memory channels,
stopping on an active channel. Press the SCAN/DUAL
button again to exit.