Harman-Kardon GPS-500 WE - Manual (Page 25)

A
T TACHING THE
GPS-500
TO THE
B
RACKET
1. Fit the bottom mounting
slot into the bracket cradle.
2. Snap the rear mounting slot
into the bracket cradle.
To unlock and remove the
unit, press the lever on the
botton of the cradle up.
L
ISTENING TO
A
UDIO IN
Y
OUR
V
EHICLE
1. Plug the supplied car
charger into your vehicle’s
12V power outlet and into
the GPS-500’s mini USB
connector. This will charge your GPS-500’s battery while you drive.
2. Use the GPS-500’s built-in speaker or connect its headphone jack to your
vehicle’s audio system (connecting cable not supplied).
!
The installation and use suggestions provided by the manufacturer
may be subject to restrictions or limitations by federal, state or local
laws. The user should determine whether the installation and use of
this device is governed by any law, prior to installation or use.
To
Car Audio
System
Built-In
Speaker
12V Power
Outlet
U
ser Manual
e d i u g + y a l p
™ GPS-500
25
1. Fit Bottom
Mounting Slot
Into Cradle
2. Snap Rear
Mounting Slot
Into Cradle