Homelite VERSA TOOL UT20818A - Manual (Page 10)

Page 10
1
2
3
STARTING AND STOPPING
See Figure 8 and 9.
TO START A COLD ENGINE:
1. Lay the trimmer on a flat, bare surface.
2. Make sure the switch is in the run “I” position.
2. Push the primer bulb 8 to 10 times.
3. Set the choke lever to the choke position .
4. Squeeze the throttle trigger to the full throttle position.
5. Pull the starter until the engine tries to run. No more
than 6 pulls.
6. Set the choke lever to the half choke position .
7. Hold the trigger and the pull starter rope until the engine
runs.
8. Run the engine 30 to 45 seconds at full throttle (with the
trigger depressed fully) on half choke position to
warm up the engine. Move the choke lever to the run
position .
TO START A WARM ENGINE:
1. Move the choke lever to the run position .
2. Hold the trigger and pull the starter rope until the engine
runs.
TO STOP THE ENGINE:
To stop the engine, press and hold the switch in the STOP
position “O”.
HALF
CHOKE
POSITION
PRIMER BULB
CHOKE LEVER
CHOKE
POSITION
RUN POSITION
Fig. 9
OPERATION
IGNITION SWITCH
I = ON TO RUN
O = OFF TO STOP
Fig. 8
THROTTLE
TRIGGER
THROTTLE INTERLOCK