Homelite UT13122 - Manual (Page 16)

Page 16
TROUBLESHOOTING
CALL US FIRST
For any questions about operating or maintaining your product,
call the Homelite ® Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
Problem Possible Cause Solution
Handle not in position. Carriage bolts not seated properly.
Handle knobs not tightened. Adjust the height of the handle and
make sure the carriage bolts are
seated properly.
Tighten handle knobs.
Mower not starting. Battery is low in charge.
Battery is either defective or will not
take a charge.
Charge the battery.
Replace the battery .
Mower cutting grass unevenly. Lawn is rough or uneven or cutting
height not set properly. Move the wheels to a higher posi-
tion. All wheels must be placed in the
same cutting height for the mower
to cut evenly.
Mower not mulching properly. Wet grass clippings sticking to the
underside of the deck. Wait until the grass dries before
mowing.
Mower hard to push. High grass, rear of mower housing
and blade dragging in heavy grass, or
cutting height too low. Raise cutting height.
Mower vibrating at higher speed. Blade is unbalanced.
Bent motor shaft. Balance the blade by grinding each
cutting edge equally.
Stop the motor, disconnect the
power source, and inspect for
damage. Have repaired by an
authorized service center before
restarting.