beautypg.com

How to use your hob know your hob, Gas burners, Important – Hotpoint GX901X User Manual

Page 6

background image

6

How To Use Your Hob

Know your Hob

Gas burners

The burners differ in size and power. Choose the most
appropriate one for the diameter of the cookware being
used.
The burner can be regulated with the corresponding
control knob "M" by using one of the following settings:

Off

High flame

Low flame

The symbols ( ) near the knobs show the position
of the relative burner on the hob.
The burners are fitted with automatic ignition and flame
failure device, which automatically cuts off the gas from
the burner in a few seconds if the flame accidentally

goes out during operation.

To ignite a burner proceed as follows:
• turn the knob counter-clockwise until the pointer is on

the high-flame symbol.

• press the relevant knob down fully to activate the

automatic gas ignition.

• keep the knob pressed down for about 10 seconds

with the flame lit to allow the flame failure device to be
heated.

• release the knob, checking that the flame is stable. If

it is not, repeat the operation.

For minimum power, turn the knob towards the low flame
symbol. Intermediate positions are possible by putting
the knob anywhere between the high and the low flame
symbol.
To turn off the burner, turn the knob clockwise to the off

position " " .

Important:

• Do not activate the automatic ignition device for more

than 15 consecutive seconds.

• Difficulty in ignition is sometimes due to air inside the

gas duct.

• If a burner flame accidentally goes out, the gas

continues to exit for a few moments before the flame
failure device activates. Turn the control knob to the
off position and do not attempt ignition again for at
least 1 minute, thereby letting the gas disperse, which
could otherwise be a danger.

• When you are not using the gas hob, check that the

knobs are in the off position " ". The main gas supply
is turned off..

A Auxiliary gas burner
B Semi-rapid gas burner
C Rapid gas-burner
D Triple ring gas burner
G Pan supports
M Control knobs for gas burners
E Ignition for gas burners
F Flame failure device - Activates if the flame accidentally

goes out (spills, drafts, etc.), interrupting the delivery of gas
to the burner.

E

F