Harbor Freight Tools 99599 - Manual (Page 6)

Page 6 For technical questions, please call 1-800-444-3353. Item 99598
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFEGUARDS section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
1. Once food is ready, plug in Power Cord (17)
and press Switch (20) to activate.
2. Feed food into Hopper Plate. Use Food Pusher (14)
to press food down Plate and into Head.
WARNING! Do NOT use fingers to push food
into Grinder. Only use Food Pusher.
3. To make sausage, insert desired
Sausage Maker (3, 4, or 5) into
Sausage Adapter (2).
4. Place wide end of Sausage Adapter against
the Head and in front of Cutting Blade.
5. Slide Cap over Sausage Maker and Adapter
and turn clockwise until Sausage Adapter
is fastened securely against housing.
cAUTION! Do not overtighten.
6. For making Kubbe, place Kubbe
Attachments (10, 11) onto Feed Screw shaft. Slide
down until the Attachment tabs fit into the slots.
7. Slide Cap over Attachments and turn clockwise
until fastened securely against housing.
WARNING! To prevent metal filings in food and
serious injury from grinder damage:
Lubricate with salad oil before use.
Do not overtighten cap (1). Stop and check cap (1)
periodically during use to ensure it remains tight.
8. To prevent accidents, turn off the appliance and
disconnect its power supply after use. Clean, then
store the appliance indoors out of children’s reach.
Inspection and Maintenance
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION OR ELEcTRIc SHOcK:
Turn the appliance off, unplug the cord, and allow the appliance to cool completely before
performing any procedure in this section.
Do not immerse the motor/heating element, cord, or plug.
TO pREVENT SERIOUS INJURy FROM AppLIANcE FAILURE:
Do not use damaged appliances.
If abnormal noise or vibration occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the appliance. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. TO cLEAR JAMS:
a. Switch off Grinder and unplug it.
b. Unscrew Cap and use a screwdriver
to remove Cutting Plate.
cAUTION! Do not remove cutting plate with fingers.
c. Remove clog.
d. Wash washable parts in warm, soapy water.
e. Dry parts and reassemble them.
3. WARNING! If the supply cord of this
appliance is damaged, it must be replaced
only by a qualified service technician.
REV 12c
Op
ERA
TION