Specifications, Unpacking, Assembly – Harbor Freight Tools 98085 User Manual

Page 4

Page 4

SKU 98085

For technical questions, please call 1-800-444-3353.

speciFications

Charge Time 6-8 hours

Power Source (5), 1.2V, 600 mAh/6V, Ni-Cd

rechargeable battery pack

Range

Detects motion over a range of

120° at 16 feet.

Delay

5-60 seconds

Working

Conditions

14° - 131° F

<80% RH

unpacking

When unpacking, check to make sure

that the item is intact and undamaged. If

any parts are missing or broken, please

call Harbor Freight Tools at the number

shown on the cover of this manual as soon

as possible.

asseMbly

read the entire iMportant

saFeguards section at the

beginning of this manual

including all text under

subheadings therein before set

up or use of this product.

Note: For additional information

regarding the parts listed in the fol-

lowing pages, refer to the Assembly

Diagram near the end of this manual.
The Security Light should be set up

at a location where you desire to

have extra lighting to detect persons

or objects moving at night or in the

dark.
Decide where you want to place the

Lamp (1) and Solar Panel (2). The

Light is equipped with a connect-

ing wire, so the Lamp (1) and Solar

Panel (2) can be installed only as far

apart as the connecting wire allows.
Choose a location that receives full,

direct sunlight a minimum of eight

hours a day. The location should not

be near nighttime light sources such

as porch lights or streetlights as this

will cause the Light to remain off.
During the day, the Solar Panel con-

verts sunlight into electricity which

recharges the batteries. The amount

of light the Solar Panel receives

depends on placement of the Light,

geographic location and weather. If

the weather is cloudy and the panel

did not receive a full charge, the Light

may not achieve full operating time.
Mount the Lamp (1) on a solid sur-

face capable of supporting the Lamp

(1) and secure enough so that it will

not move when exposed to vibration

or wind.

rear-

mounting

holes

inside-

mounting

holes

Figure 1

7. To mount the Lamp (1), the Screws

(5) can be inserted into either the

rear mounting holes or to the inside

mounting holes as shown in Fig. 1.

If using the inside mounting holes,