Healthrider HCTL05910 - Manual (Page 22)

22
PROBLEM SOLUTION
a. Make sure that the power cord is plugged into a surge protector, and that the
surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG
IN THEPOWER CORD on page 7.) Use only a CUL-listed surge protector, rated
at 15 amps, with a 14-gauge cord of 1,5 m (5 ft.) or less in length. Important: The
treadmill is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure
that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill
near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press the
switch back in.
d. Check the on/off switch located on the treadmill
near the power cord. The switch must be in the on
position.
a. Check the circuit breaker located on the treadmill frame near the power cord (see
1. c. above). If the circuit breaker has tripped, wait for five minutes and then press
the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console and then reinsert it.
d. Make sure that the on/off switch is in the on position (see 1. d. above).
a. Make sure that only an appropriate surge suppressor is used (see 1. a. above).
b. If the walking belt is overtightened, tread-
mill performance may decrease and the
walking belt may become damaged.
Remove the key and UNPLUG THE
POWER CORD. Using the allen wrench,
turn both rear roller adjustment bolts
counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you
should be able to lift each side of the
walking belt 3 to 4 inches off the walking
platform. Be careful to keep the walking
belt centered. Plug in the power cord, insert the key and run the treadmill for a few
minutes. Repeat until the walking belt is properly tightened.
1. The power does not
turn on
2. The power turns off
during use
3. The walking belt
slows when walked
on
TROUBLE-SHOOTING AND MAINTENANCE
Most treadmill problems can be solved by following the instructions below. If further assistance is
needed, please call our Customer Service Department toll-free at 1-888-936-4266, Monday through Friday,
8h00 to 18h30, Eastern Standard Time (excluding holidays).
Reset
On
Position
T i d Reset Tripped
Rear Roller Adjustment Bolts
3–4”
b
c
d