Harbor Freight Tools 95160 - Manual (Page 4)

SKU 95160 For technical questions, please call 1-800-444-3353 PAGE 4
16. WARNING! The brass components of this product contain lead, a chemical
known to the State of California to cause cancer and birth defects (or other
reproductive harm).
California Health & Safety Code (25249.5 et seq.)
17. WARNING! The warnings and cautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
UNPACKING
When unpacking, check to make sure all the parts shown in the Parts List on page 6
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the front cover of this manual as soon as possible.
SAVE THESE INSTRUCTIONS
PRODUCT USES
1. The Template Guide Set will work with any template, pattern, or jig for duplicating
routing of edges or interior surfaces. Uses are as follows: A. Stair routing.
B. Pattern routing. C. General routing. D. Hinge routing. E. Dovetailing.
TEMPLATE
LOCKING
NUT
(8, 9)
ROUTER
BASE
PLATE
TEMPLATE
GUIDE
(1, 2, 3, 4, 5, 6, 7)
MATERIAL BEING CUT
TEMPLATE
TEMPLATE
TEMPLATE
EDGE ROUTING
USING
TEMPLATE GUIDES
ROUTER BIT
SAMPLE
O F
EDGE ROUTING
SAMPLE
O F
INSET ROUTING
TO USE:
1. Install the Template Guide (1, 2, 3, 4, 5, 6, 7) into the router sub-base from
underneath. The Router base opening must have a 1-3/16” opening.
2. Then secure the Template Guide (1, 2, 3, 4, 5, 6, 7) by tightening the Template
Lock Nut (8 or 9) onto the threads protruding from the Template Guide.