Hunter Fan 82022 - Manual (Page 11)

EXISTING FAN
C11
C12
E
F
Existing Construction – accessible from above
11
NO EXISTING FAN
8” 8 1
/2”
OR
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new
motor housing (8”x 8 1/2”).
Cut out an opening for the housing.
Use the motor housing as a template to mark position.
Slide the mounting rails into brackets.
position the correct depth mark at the bottom edge of the
joist based on the thickness of your sheetrock.
5/8
1/2
5/8
1/2
C13 C14
Mark position of screws by using holes as a template.
42949-01 04/18/2007