Harbor Freight Tools 40070 - Manual (Page 9)

Page 9 SKU 40070 For technical questions, please call 1-800-444-3353.
SYMBOLOGY
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any parts
are missing or broken, please call Harbor Freight Tools at the number shown on the cover
of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 12.
CAUTION: Always make sure the Power Cord (17) of the Sander is unplugged from its
electrical outlet prior to making any adjustments or assembling to the tool.
ATTACHING THE DUST COLLECTION CHUTE (0)
1. Turn the Chute (0) so that the tab on top of the rectangular end faces up. Snap it in
place into the rectangular shaft at the back of the Sander.
2. Connect a 1-1/4” dust collection hose from the Chute to your dust collection system
(hose and system not included).
3. The Dust Collection Chute (0) will only work if the sandpaper has holes that line up
with the 6 dust collection holes in the Backing Pad (28). (There are 4 other holes in
the Backing Pad for the Screws (29).)