haier ECR1 7 - Manual (Page 7)

6
English
Electrical Requirement
t.BLFTVSFUIFSFJTBTVJUBCMFQPXFSPVUMFU WPMUT
BNQTPVUMFUXJUI
proper grounding to power the refrigerator.
t"WPJEUIFVTFPGUISFFQSPOHBEBQUFSTPSDVUUJOHPGGUIFUIJSEHSPVOEJOHQSPOH
in order to accommodate a two prong outlet. This is a dangerous practice since
it provides no effective grounding for the refrigerator and may result in shock
hazard.
Use of Extension Cords
t"WPJEUIFVTFPGBOFYUFOTJPODPSECFDBVTFPGQPUFOUJBMTBGFUZIB[BSETVOEFS
certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
Installation Limitations
t%POPUJOTUBMMZPVSSFGSJHFSBUPSJOBOZMPDBUJPOOPUQSPQFSMZJOTVMBUFEPSIFBUFE
e.g. garage, etc. Your refrigerator was not designed to operate in temperature
settings below 55˚ Fahrenheit.
t4FMFDUBTVJUBCMFMPDBUJPOGPSUIFSFGSJHFSBUPSPOBIBSEFWFOTVSGBDFBXBZ
from direct sunlight or heat source, e.g. radiators, baseboard heaters, cooking
appliances, etc. Any floor unevenness should be corrected with the leveling legs
located on the front bottom corners of the refrigerator.
NOTE: As the door gets pressed in during shipping, after reversing the door, the
gasket may have to be reset. This is done to prevent the cool refrigerated
air from escaping. If there is a gap between the door gasket and the
cabinet, set the gasket by gently pulling it out to seal the gap.