Harbor Freight Tools 93874 - Manual (Page 14)

SKU 93874 For technical questions, please call 1-800-444-3353. Page 14
8. NOTE: Always dispose of old Engine oil and old Air Compressor oil in accor-
dance with local, state, and federal regulations.
front Belt Guard section. Loosen the four Screws (31) at the base of the Engine.
Slide the Engine toward the Air Compressor to loosen tension on the V-Belt (44).
Remove the old V-Belt from the Flywheel (39A) and Pulley (37). Install the new
V-Belt (A47/13 x 11.94) on the Flywheel and Pulley. Then reinstall the front Belt
Guard section and secure in place with the six Screws previously removed. (See
Figure G and Assy. Diagram.)
9. CAUTION! All maintenance, service, or repairs not mentioned in this
manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST
AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEI-
THER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE-
MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARIS-
ING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE-
MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.